NVS – SGBox Next Generation SIEM & SOAR https://www.sgbox.eu Next Generation SIEM & SOAR Mon, 29 Jun 2026 14:45:44 +0000 en-US hourly 1 https://wordpress.org/?v=7.0.2 https://www.sgbox.eu/wp-content/uploads/2025/02/cropped-SGBox-symbol-png-32x32.webp NVS – SGBox Next Generation SIEM & SOAR https://www.sgbox.eu 32 32 Add Probe https://www.sgbox.eu/en/knowledge-base/scm-system-control-management-en/network-it-en-en/configure-a-probe/ Tue, 17 Dec 2019 14:33:23 +0000 http://10.253.1.91/?post_type=epkb_post_type_1&p=2794

Configure a collector as a probe in SGBox

This section explains how to configure a collector as a probe in SGBox to monitor the status of the collector directly from the tenant where it is added.

Requirements:

  • A collector must be deployed and configured. Look this section to see how to configure it.

Connect to the SGBox web interface.
Go under SCM > Network > Probe
Add Probe

Click on ➕ Add new probe button and specify:

  • Collector IP Address
  • Collector Name
  • Probe type: SGBox Standard Probe
  • (optional) Network or networks that belong to this collector

Add Probe
Click on SAVE in order to save configuration.
After a few minutes, information about the status of the collector should be displayed.Add Probe

]]> Prepare an asset to NVS https://www.sgbox.eu/en/knowledge-base/nvs-network-vulnerabilty-scanner-en/scan/prepare-an-asset-to-nvs/ Fri, 28 Jun 2019 15:29:37 +0000 https://10.253.1.90/sgbox/EN/?post_type=epkb_post_type_1&p=1680

How to prepare an asset to NVS

This article explains how to prepare an asset to NVS. In this way, the hosts that are part of it, can be used as target of the scan test. For more information about the assets, look the article that explains how to create an asset.

Requirements:

  • The asset must be created. Look this section to see how to create it.

Connect to the SGBox web interface.
SGBOX > SCM > Network > Asset

Prepare an asset to NVS

Click on Edit button of the asset you want to modify. In our caseAsset1.

Prepare an asset to NVS

Asset configuration window is shown.
In Assign Module tab, select Network Vunerability Scanner and click on ADD.

Prepare an asset to NVS

In Assign NVS Policy tab, select the network on which our hosts belong and the policy you want to use.
In our case, the previously created policy: Openvas Default Scan. Click on Modify to save changes.

Prepare an asset to NVS

]]>